touchless3dtracking/touchless_tracking/touchless_tracking.ino
Phyks 91d6b5af4b Handle 3 electrodes
The code should be able to handle 3 electrodes for R, G and B. Didn't
test it so far (need 2 other electrodes).
2013-09-30 23:05:02 +02:00

101 lines
2.5 KiB
C++

/* Touchless tracking
* ==================
* This code takes as many measurements as it can at approximately
* 10Hz = 60 Hz / (2 full cycles * 3 sensors).
*
* The code takes as many measurements as possible on the period of two
* cycles of the main power frequency, in order to cancel out any potential
* coupling.
*
* Original code was found on instructables :
* http://www.instructables.com/id/DIY-3D-Controller/
*
* Code slightly modified and commented by Phyks for HackENS
*
* As I found the code on Instructables and I don't give a damn to the
* modifications I made, you may reuse it freely by writing where you
* found it.
*/
#define resolution 8
// Frequency of main power to avoid coupling
#define mains 50
// Time between measures
#define refresh 2 * 1000000 / mains
// Pins to use
// Must be between 8 and 13 to use this code without
// modifications (PORTB is for pins 8 to 13)
//
// Note : If you change pin numbers, you *must* change the mask.
// See arduino doc for more info.
#define PIN_R 8
#define MASK_R B00000001
#define PIN_G 9
#define MASK_G B00000010
#define PIN_B 10
#define MASK_B B00000100
// Counter for the timer
extern volatile unsigned long timer0_overflow_count;
void startTimer() {
timer0_overflow_count = 0;
TCNT0 = 0; // Initialize counter value to 0
}
unsigned long checkTimer() {
return ((timer0_overflow_count << 8) + TCNT0) << 2;
}
long time(int pin, byte mask) {
unsigned long count = 0, total = 0;
while(checkTimer() < refresh) {
// Note : pinMode is about 6 times slower than assigning
// DDRB directly, but that pause is important
// Set pin as output and LOW, see arduino doc for info on PORTB
pinMode(pin, OUTPUT);
PORTB = 0;
// Set it as INPUT to take measure
pinMode(pin, INPUT);
// While PINB is low, increment counter
while((PINB & mask) == 0)
count++;
total++;
}
// Restart timer for next measurement
startTimer();
// Return the measurement result
return (count << resolution) / total;
}
void setup() {
// Initialize serial communication
Serial.begin(115200);
// INPUT on pins
pinMode(PIN_R, INPUT);
pinMode(PIN_G, INPUT);
pinMode(PIN_B, INPUT);
// Start timer
startTimer();
}
void loop() {
// Print output to serial in decimal
Serial.print(time(PIN_R, MASK_R), DEC);
Serial.print(" ");
Serial.print(time(PIN_G, MASK_G), DEC);
Serial.print(" ");
Serial.print(time(PIN_B, MASK_B), DEC);
Serial.print("\n");
}